Denon DP-29F - Manual (Page 6)

ENGLISH
6
2 BEFORE USING THE TURNTABLE
Rubber mat
Spindle
Ribbon tape
Driving roller
Drive belt
Equalizer Amplifier switch
This unit has built-in RIAA equalizer amplifier, so it can be
connected to an amplifier without PHONO (turntable) input
jack. According to the amplifier, set the EQUALIZER
AMPLIFIER SWITCH.
When the unit is connected
to the PHONO (MM) jacks:
Rear panel of the
amplifier
L
R
PHONO
ON OFF
White
Red
When the unit is connected
to the AUX jacks, etc:
Rear panel of the
amplifier
L
R
AUX
ON OFF
White
Red
• The drive belt is fitted under the platter. When assembling the
player, please handle the drive belt with care.
• Remove all packing materials attached to the tone arm, except
that on the stylus, and then open the dust cover and assemble.
Remove the stylus cover after assembling.
1
Hold the platter by the holes at its outer surface, and
then carefully lower the platter so that the center
spindle enters the center hole.
Rotate the platter until one of its outer openings is
aligned with the driving roller. (Refer to illustration.)
2
3
Gently grasp and pull at the ribbon tape of the drive
belt that is would under the turntable, and then
extend the belt around the driving roller. (After
attaching, remove the ribbon tape.)
In order to make sure that the drive belt has been
correctly fitted, slowly rotate the platter 3 or 4 turns.
Place the rubber mat on the platter.
IMPORTANT! Please Check.
Check that the drive belt and ribbon tape have been attached
under the platter. Grasp the ribbon tape as shown in the
illustration to the left, and extend it onto the driving roller.