Acrosser AR-B5230 - Manual (Page 30)

AR-B5230 Series User Manual
30
Exit Without Saving
Pressing on this
item for confirmation:
Quit without saving
(Y/N)? Y
This allows you to exit Setup without
storing any changes in CMOS. The
previous selections remain in effect.
This shall exit the Setup utility and
restart your computer.
Set Password
Pressing on this
item for confirmation:
ENTER PASSWORD:
When a password has been
enabled, you will be prompted to
enter your password every time you
try to enter Setup. This prevents
unauthorized persons from
changing any part of your system
configuration.
Type the password, up to eight
characters in length, and press
. The password typed now
will clear any previous password
from the CMOS memory. You will be
asked to confirm the password.
Type the password again and press
. You may also press
to abort the selection and not enter
a password.
To disable a password, just press
when you are prompted to
enter the password. A message will
confirm that the password will be
disabled. Once the password is
disabled, the system will boot and
you can enter Setup freely.