Acrosser AR-B1042 - Manual (Page 25)

AR-B1042 User s Guide
4-3
4.1.3 AutoCAD R12
These drivers are designed to work with AutoCAD R12. They conform to the Autodesk Device Interface (ADI) for
Rendering drivers and Display drivers. These display drivers accelerate redraw, pan, and zoom functions.
(1) Driver Installation
To install the drivers, follow these instructions:
Step 1 : Place the Display Driver Diskette #1 in drive A. Type A: to make this the default drive.
Type SETUP to run the SETUP program. Press any key to get to the applications list.
Using the arrow keys, select AutoCAD Release 12 and press . This will display a list of
supported driver resolutions. Using the arrow keys and the key, select the resolutions
that are appropriate for your monitor. When all of the desired resolutions have been selected, press
to begin the installation. At this point you will be asked for a drive and directory to copy the
driver files. Enter the drive and directory that contains the installed AutoCAD R12. You may be
asked to change display driver diskettes, and if the destination directory does not exist you will be
asked for confirmation. When the installation is complete, press any key to continue. Press
followed by Y to exit to DOS.
Step 2 : Go to the AutoCAD directory where the new drivers were installed and run the driver installation
program by typing ACAD12 –r . This program will configure your AutoCAD R12 to use the
new display drivers. Select TurboDLD Classic.
(2) Configuring TurboDLD Driver
Select Configure Video Display. In Display Device Configuration choose Select Graphics Board/Resolution. Then
choose Select Display Graphics Board. After choosing a Graphics Board, go to Select Display Resolution. After
selected Display Resolution, save the new configuration and return to the main menu.
1. Basic Configuration Menu
This menu allows you to modify:
•
Number Of AutoCAD Command Lines
•
Screen Configuration Dual/Single/Text Window on Single
•
Select Font from List 6x8/8x8/8x14/8x16/12x20/12x24
•
Select Font Filter All Fonts/IS08859/jisx0201.1976
2. User Interface Configuration
•
Double Click Interval Time
•
BP Button
•
BP Highlight
Patt. Line/Xor Rect/Both
•
BP Refresh
Enable/Disable
3. Expert Configuration Menu
This menu allows you to modify:
•
Display List
Enable/Disable
•
Use Acad 31 bit space?
Yes/No
•
Internal Command Echo
Enable/Disable
•
BP Zoom Mode
Freeze/Float
•
Disable DL in PSpace?
Yes/No