Acrosser AR-B1565 - Manual (Page 27)

AR-B1565/1565A User’s Guide
26
3.2.24 LVDS Supported Voltage LVDS1 Select (JP12) (Only For AR-B1565)
5V
5 3 1
6 4 2
5 3 1
6 4 2
3.3V
Factory Preset
3.2.25 Ethernet Setup (JP9, JP10)
In here not install is called Enable. If it enable, it can pass through Ethernet. And when it disable, it can’t pass
through Ethernet.
Factory Preset
JP9 ON: Enable LAN1 (Factory Preset)
OFF: Disable LAN1
JP10 ON: Enable LAN2 (Factory Preset)
OFF: Disable LAN2
3.2.26 PCI SOLT Select (JP1)
It must be Jumper, when you need to connect the SLOT.
1
2
3
2-3 Support one PCI Card
(Factory preset)
1-2 When riser card is applied
Factory Preset
3.2.27 TV-Out Connector (TV1) (Only For AR-B1565A)
LVDS1 Signal LVDS1 Signal
1 TXOUT0- 14 GND
2 TXOUT0+
15 GND
3 TXOUT1- 16 GND
4 TXOUT1+
17 VTX5
5 TXOUT2- 18 VTX5
6 TXOUT2+
19 VTREV
7 TXCLK- 20 GND
8 TXCLK+ 21 GND
9 TXOUT3- 22 VTX12
10 TXOUT3+ 23 VTX12
11 VTKBP 24 GND
12 NC 25 GND
13 NC 26 NC