Acrosser AR-B1565 - Manual (Page 16)

AR-B1565/1565A User!s Guide
15
3. SETTING UP THE SYSTEM
This section describes pin assignments of on board connector and jumper settings.
! Overview
! System Setting
3.1 OVERVIEW
AR-B1565/1565A is a Pentium Grade CPU Board, which supports Ethernet, DOC, SSD, and audio card (AR-B9425A)
functions. This section provides the hardware’s jumper settings, the connectors’ locations, and the pin assignments.
B
External System Location
3.2 SYSTEM SETTING
Jumper pins allow you to set specific system parameters. Set them by changing the pin location of jumper blocks.
(A jumper block is a small plastic-encased conductor that slips over the pins.) To change a jumper setting, remove
the jumper from its current location with your fingers or small needle-nosed pliers. Place the jumper over the two
pins designated for the desired setting. Press the jumper evenly onto the pins. Be careful not to bend the pins.
CAUTION: Do not touch any electronic components unless you are safely grounded. Wear a grounded wrist strap
or touch an exposed metal part of the system unit chassis. The static discharges from your fingers can
permanently damage electronic components.