Acrosser AR-B9622 - Manual (Page 35)

AR-B9622 User¡¦ s Guide
5-1
5. INSTALLATION
This chapter describes the procedure of the installation. The following topics are covered:
l Overview
l Utility Diskette
l Watchdog Timer
5.1 OVERVIEW
This chapter provides information for you to set up a working system based on the AR-B9622 CPU board.
Carefully read the details of the CPU board’ s hardware descriptions before installation, especially the jumper
settings, switch settings and cable connections.
Follow the steps listed below for proper installation:
Step 1 : Read the CPU board’ s hardware description in this manual.
Step 2 : Set jumpers.
Step 3 : Make sure that the power supply connected to your passive CPU board is turned off.
Step 4 : Connect all necessary cables. Make sure that the FDC, HDC, serial and parallel cables are
connected to pin 1 of the related connector.
Step 5 : Connect the hard disk/floppy disk flat cables from the CPU board to the drives. Connect a power
source to each drive.
Step 6 : Plug the keyboard into the keyboard connector.
Step 7 : Turn on the power.
Step 8: Configure your system with the BIOS Setup program then re-boot your system.
Step 9: If the CPU board does not work, turn off the power and read the hardware description carefully
again.
Step 10: If the CPU board still does not perform properly, return the board to your dealer for immediate
service.
5.2 UTILITY DISKETTE
AR-B9622 provides two VGA driver diskettes, supporting WIN31 & DOS applications. If your operating system is
the other operating system, please contact Acrosser that will provide the technical supporting for the VGA
resolution.
There are two diskettes: disk 1 is for WIN31 & MS-DOS VGA resolution, disk 2 is for the network utility and
manual. Every diskette is attached with the README.* file. Please refer to the file of README for any
troubleshooting before installing the driver.