Acrosser AR-B1690 - Manual (Page 5)

AR-B1690 User’s Guide
5
0.6 ORGANIZATION
This information for users covers the following topics (see the Table of Contents for a detailed listing):
Chapter 1, “Introduction”, provides specifications and packing list.
Chapter 2, “Setting Up System”, describes how to adjust the jumpers and the connector settings.
Chapter 3,“CRT/LCD Flat Panel Display”, describes the configuration and installation procedure for using LCD and
CRT displays.
Chapter 4, “Watchdog Timer”, describes watchdog timer setting and trigger.
Chapter 5, “BIOS Console”, provides the BIOS settings options.
Appendix A, Memory & I/O Map
Appendix B, Interrupt Request (IRQ)
0.7 STATIC ELECTRICITY PRECAUTIONS
Before removing the board from its anti-static bag, read this section about static electricity precautions.
Static electricity is a constant danger to computer systems. The charge that can build up in your body may be more
than sufficient to damage integrated circuits on any PC board. It is, therefore, important to observe basic
precautions whenever you use or handle computer components. Although areas with humid climates are much
less prone to static build-up, it is always best to safeguard against accidents that may result in expensive repairs.
The following measures should be sufficient to protect your equipment from static discharge:
„
Touch a grounded metal object to discharge the static electricity in your body (or ideally, wear a grounded
wrist strap).
„ When unpacking and handling the board or other system components, place all materials on an anti-static
surface.
„ Be careful not to touch the components on the board, especially the “golden finger” connectors on the
bottom of the board.