Acrosser AR-B1631 - Manual (Page 5)

AR-B1631 User’s Guide
CDIN1
CN8 JP5
JP1
CN10
JRS1
AUDIO1
COM2
COM3
COM4
J2 DIO1 LPT1
J3
JP4
CN9
JP6
CN4
J5 IR1
2.2 SYSTEM SETTINGS
Jumper pins allow you to set specific system parameters. Set them by changing the pin location of the jumper
blocks. (A jumper block is a small plastic-encased conductor that slips over the pins.) To change a jumper
setting, remove the jumper from its current location with your fingers or small needle-nosed pliers. Place the
jumper over the two pins designated for the desired setting. Press the jumper evenly onto the pins. Be careful
not to bend the pins.
We will show the locations of the AR-B1631 jumper pins, and the factory-default settings.
CAUTION: Do not touch any electronic components unless you are safely grounded. Wear a
grounded wrist strap or touch an exposed metal part of the system unit chassis. The static discharges
from your fingers can permanently damage electronic components.
2.2.1 JP5 (SERIRQ)
CLOSE SERIRQ
2.2.2 JP1 (POWER ON)
POWER BUTTON
PIN HEADER
5