Acrosser AR-B1631 - Manual (Page 11)

AR-B1631 User’s Guide
NOTE 1：
For using both of Hard Disk And Compact Flash, you have to use the ATA33 IDE
cable.
IF you want to use ATA66/100 mode with Hard Disk, you must put jumper on
JP6 and use the special IDE cable.
The cable is like below：
IDE HOST
IDE DEVICE
PDIAG
In usual ATA66/100 cable the
Pin 34 at host side is defined
as CABLE ID and connected
to ground.
In special cable, the Pin 34 is
defined as PDIAG. And cannot
connect to ground
The special cable must connect this PDIAG signal from host
side to device side.
In usual ATA66/100 cable, the Pin 34 between host and
device side are disconnected.
PIN34
NOTE 2：
USB connectors (USB1 & USB2) and USB Pin headers cannot use together. And
if you want to use USB connectors, you must take the USB cable on Pin Header.
3. LCD FLAT PANEL DISPLAY
This chapter describes the configuration and installation procedures for LCD displays.
LVDS1
AR-B1631
LCD
Panel
Inverter
Backlight
connect
to J5
Backlight
Power
LCD Panel Block Diagram
Please visit our web site or contact with our technical support department for supports of LCD connecting.
11