3DLABS Oxygen VX1-1600SW - Manual (Page 12)

Installation
3Dlabs Oxygen VX1-1600SW User's Guide 2
Getting Ready
To successfully use your new Oxygen VX1-1600SW card, you must install the card and the accompanying
driver software. Whether you install your new card or the driver first depends on whether a video card is
already present in your system.
If there is a video card in your system: Uninstall the drivers for the existing card, then install the Oxygen
driver. Once the new driver is loaded, remove the old card and install your Oxygen VX1-1600SW card. The
instructions for uninstalling an old driver and installing the new driver begin on page 6.
If there is not a video card in your system: Install your new card as described in the Installing Hardware
section, below, then install the driver.
Note: Be sure to register your new card using one of the options described on page 7.
Before You Start
7DNH HYHU\ SRVVLEOH SUHFDXWLRQ DJDLQVW VWDWLF HOHFWULFLW\ DV \RX SUHSDUH WR LQVWDOO WKH FDUG VWDWLF FDQ
GDPDJH FRPSRQHQWV
FDUSHW 6DYH DQ\ ZRUN LQ SURJUHVV DQG H[LW DQ\ RSHQ DSSOLFDWLRQV $OZD\V EDFN XS \RXU V\VWHP EHIRUH \RX
LQVWDOO QHZ KDUGZDUH RU VRIWZDUH
+DYH D 3KLOLSVKHDG VFUHZGULYHU UHDG\