Dacor EPICURE EG486 - Manual (Page 7)

5
Stack Burners
Put the burner rings on the burner bases as 1.
shown below. Match the correct sizes. The
bottom of the correct size burner ring fits inside
the top of the matching burner base.
Turn the ring until it drops into place. Twist each
2.
ring back and forth slightly to make sure it is
properly seated.
Put the burner caps on top of the burner rings.
3.
The ridge around the bottom edge of the cap
goes around the top of the burner ring.
Installing the Grates
Gently set the grates on top of the spill tray. Put the
legs of each grate into the corresponding dimples.
On model EG366, the middle grate is larger than the
other two.
Setting Up Your Cooktop
Burner and Grate Assembly
WARNING
Assemble the burners and grates only when the cooktop
is cool.
Crown Burners
Put the burner heads in place as shown below. 1.
The locating tab on the burner head goes in the
keyed hole as shown.
Put the burner rings on the burner heads as
2.
shown below. Match the tabs on the bottom of
the ring to the slots on the burner head. Twist
each ring back and forth slightly to make sure it
is properly seated.
Put the burner caps on top of the burner rings.
3.
The ridge around the bottom edge of the cap
goes around the top of the burner ring.
Stack Burner Assembly
Step 1
Step 2
Step 3
Ridge on bottom
of burner cap
Burner ring
Burner base
Crown Burner Assembly
Step 1
Slots
Tabs
Step 2
Step 3
Ridge on bottom
of burner cap
Put locating tab
into keyed hole
Burner ring
Burner head
Burner base
Keyed hole
continued...