Directed Electronics PYTHON 480XP - Manual (Page 30)

30
© 2002 Directed Electronics, Inc.
Tach Learning
T Too lleeaarrnn tthhee ttaacchh ssiiggnnaall::
1. Start the vehicle with the key.
2. Within 5 seconds, press and hold the Valet/program switch.
3. The LED will light constant when the tach signal is learned.
4. Release the Valet/program switch.
NOTE: A dim or pulsing LED when learning tach means the unit has not learned the tach signal.
Test all connections, and if good, relocate the tach input wire and continue with tach learning
procedure.
Shutdown Diagnostics
The unit has the ability to report the cause of the last shutdown of the remote start system.
T Too eenntteerr ddiiaaggnnoossttiicc m mooddee::
1. Turn the ignition off.
2. Press and hold the Valet/program switch.
3. Turn the ignition on then off again.