Desa RH10PT - Manual (Page 7)

www.desatech.com 110373-01E 7
3. Insert wall anchor (wings first) into hole. Tap
anchor flush to wall.
4. For thin walls (1/2" or less), insert red key
into wall anchor. Push red key to “pop” open
anchor wings (see Figure 5).
IMPORTANT: Do not hammer key! For thick
walls (over 1/2" thick) or solid walls, do not
pop open wings.
5. Tighten two screws until 1/16" space (thick-
ness of penny) is between screwheads and wall
(see Figure 6).
INSTALLATION
Continued
Figure 4 - Folding Anchor
Figure 5 - Popping Open Anchor Wings
For Thin Walls
Thin Walls
(1/4" to
1/2" thick)
Figure 6 - Tightening Anchors
1/16"
Space
Thin or Thick
Wall (thick
wall shown)
Solid
Wall
Figure 7 - Location Of Keyhole Slots On
Back Panel Of Heater
Keyhole Slots
Figure 8 - Removing Front Panel Of
Heater
Placing Heater On Mounting Screws
1. Locate two keyhole slots on back panel of
heater (see Figure 7).
2. Place large openings of slots over screwheads.
Slide heater down until screws are in small
portion of slots.
Removing Front Panel Of Heater
1. Remove two screws near bottom corners of
front panel.
2. Lift straight up on grill guard until it stops.
Grill guard will slide up about 1/4".
3. Pull bottom of front panel forward, then
down.
Installing Bottom Mounting Screw
1. Locate bottom mounting hole. This hole is
near bottom on back panel of heater (see
Figure 9).
2. Mark screw location on wall.
3. Remove heater from wall.
4. If installing bottom mounting screw into hol-
low or solid wall, install wall anchor. Follow
steps 1 through 5 under Attaching To Wall
Anchor Method, page 6. If installing bottom
mounting screw into wall stud, drill hole at
marked location using 9/64" drill bit.
5. Replace heater on wall.
6. Insert bottom anchor screw through back panel
into bottom anchor or drilled hole (see Figure 9).
7. Tighten screw until heater is firmly secured to
wall. Do not over tighten.
Note: Do not replace front panel at this time.
Replace front panel after making gas connections
and checking for leaks (see pages 8 through 10).
Figure 9 - Installing Bottom Mounting
Screw