beautypg.com

Programming additional transmitters, Battery replacement – Dodge 2007 Charger SRT8 User Manual

Page 19

background image

• You may need to be less than 23 feet (7 meters) from

the vehicle when using the transmitter to turn off the
panic alarm due to the radio frequency noises emitted
by the system.

Programming Additional Transmitters
Refer to SENTRY KEY “Customer Key Programming.”
(See page 14 for more information.)

If you do not have a programmed transmitter, contact
your dealer for details.

Battery Replacement
The recommended replacement battery is CR2032.

NOTE:

Do not touch the battery terminals that are on

the back housing or the printed circuit board.

1. With the transmitter buttons facing downward, re-
move the small screw (if equipped).

2. Separate the two halves of the transmitter with a flat
blade tool. Do not damage the rubber seal during re-
moval.

3. Remove and replace the battery. Avoid touching the
new battery with your fingers. Skin oils may cause
battery deterioration. If you touch a battery, clean it with
rubbing alcohol.

4. To assemble the transmitter case, snap the two halves
together. If so equipped, install and tighten the screw
until snug. Make sure there is an even “gap” between the
two halves.

5. Test the transmitter operation.

Separating Transmitter Halves

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

19

2

This manual is related to the following products: