Directed Electronics 2000 User Manual

Page 14

2001 Directed Electronics, Inc.

You can prevent your security system from automatically arming

and triggering by using Valet

Mode. This is very useful when

washing or servicing the vehicle. In Valet Mode, the security sys-

tem will not arm, even with the remote transmitter, but all con-

venience functions will continue to operate normally.

To enter or exit Valet

Mode with the Valet switch:

1. Turn the ignition on.

2. Turn the ignition off.

3. Press and release the Valet

switch within 10 seconds.

The status LED will light solidly

if you are entering Valet Mode, and it will go out if you are exit-

ing Valet Mode.

Your system has DEI

’s Nuisance Prevention

Circuitry (NPC

). It

prevents annoying repetitive trigger sequences due to faulty sen-

sors or environmental conditions such as thunder, jackhammers,

airport noise, etc. Here’s how it works:

The alarm triggers three times. Each time, the same shock sensor

or switch is triggering the alarm. The three triggers are within 60

minutes of each other. NPC will interpret this pattern of triggers

as false alarms. After the third trigger, NPC ignores, or bypasses,

Nuisance Prevention

Circuitry

DRW-35

Valet

Mode