Directed Electronics 2000 - Manual (Page 11)

8
© 2001 Directed Electronics, Inc.
■ Pressing
a third time within five seconds: The siren
chirps three times followed by a long chirp. Zone Four is now
bypassed.
■ Pressing
a fourth time within five seconds: The siren
chirps four times followed by a long chirp. Zones Two and
Four are now bypassed.
■ Pressing
a fifth time within five seconds: The siren
chirps five times followed by a long chirp. All input zones,
except the ignition (Zone 5), are now bypassed.
NOTE: For watercraft, we recommend turning off the shock sensor (Zone
Two) whenever the craft is in the water to avoid false triggers.
NOTE: Multi-Level Security Arming only applies to a single arming cycle.
Once the system is disarmed and then re-armed, all the zones will be
active again.
To disarm the system, press . You will hear two chirps, and the
lights will flash twice. If the siren chirps either four or five times
when disarming, refer to the Diagnostics section of this guide.
This is called Tamper Alert.
This feature allows you to disarm the system without the transmit-
ter should it be lost, damaged or disabled. In order to disarm
without a transmitter, you must have the ignition key and know
where the Valet ® switch is located. Be sure to check with the
installer for the location of the Valet switch.
Disarming Without a Transmitter
Disarming