AEG 2200 I W-D - Manual (Page 8)

Installation instructions
Carefully remove the right polythene
bag.
Carefylly remove the central and left
polythene bags.
6
Re-fit the bottom panel using the 4
screws supplied with the booklet and
the previously removed screw.
Set the machine upright and unscrew
the two remaining rear screws.
Door reversal & building-under
Preparation and assembiy of
the door
It is possible to change the door
opening side so as to match it
perfectly with the rest of the kitchen
furniture.
The machine is originally pre-arranged
for assembly of a door with right side
opening.
in this case it is sufficient to screw-in
on the door the two hinges (1) and
the oounter-magnet (5) in the right
position.
Cabinet’s door
The dimensions of the cabinet’s door
shouid be:
width
thickness 595-i-3 mm
16 to 22 mm
The height (C) cannot be given, since
It depends on the height of the
adjacent furniture, e.g. height of the
kick plate of the kitchen unit.
if necessary, the piastic seaiing
profiles underneath the controi panei
can be removed by unscrewing the
two screws.
To mount the hinges on the door it is
necessary to drili 2 holes (dia. 35 mm,
depth 14 mm) on the door’s inner
side.
The distance between the hoies must
be 416 mm.
The dimension (B) (from upper edge
of the door to the center of the hole)
cannot be given, since it depends on
the adjacent cabinets’ dimensions.
The required dimensions are given in
the picture.
The hinges will be fixed to the door
by means of the 4x16 mm screws.
37