AEG 2200 I W-D - Manual (Page 7)

Door reversal & building-under
Mounting the door
Now fix the hinges to the machine by
means of the M 5 x 8 mm screws. To
compensate for possible uneven
thickness of the door the hinges can
be adjusted horizontaiiy.
To aiign the door perfectiy it may
sometimes be necessary to adjust the
height of the piates {2). This can be
done by ioosening the piastic screw
(3).
Counter-Magnet (5)
The door is kept ciosed by a
magnetic closure.
To enabie the ciosure to operate a
counter-magnet must be screwed into
the door inner side (steei disk with
rubber ring).
its position must correspond with the
magnet on the appiiance (see
picture).
Change of door opening
direction
Shouid a change of the opening
direction to the left side be required,
operate as foitows:
• Unscrew the door magnet (4) and
the rubber buffer (4) and take out the
plastic inserts.
• Fit the hinge fastening piates (2)
on the right side.
• Fit the magnet, the rubber buffer
and the piastic inserts on the ieft
side.
38
Installation instructions
Caution
Before starting the machine up, the
packing must be removed as follows.
Note
You are advised to keep ali the
packing for re-use in case the
machine has to be transported again.
1
Using a spanner unscrew and remove
the rear right screw.
Lay the machine on its back making
sure that the hoses are not squashed.
Remove the polystyrene base and
take off the bottom panel by
unscrewing the central screw.