Avanti D-24 - Manual (Page 9)

Installation Instructions
SPECIAL INSTALLATION REQUIREMENTS
ALCOVE OR CLOSET INSTALLATION
• VVARNCVG: To reduce the risk of fire, this drver ML'ST BE EXH-At STED TO THE
OLTDOORS. See EXRAUST IXFOILVLAflON section.
• Minimum clearances betv^ een diyer cabinet and adjacent wails or other surfaces are:
2” either side 3" from and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52“( 132cm).
• Goset door must be louvered or othenvise ventilated and must contain a minimum of
60 sq. in. of open area equally distributed. If this closet contains both a washer and a
dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with the dryer.
MINIMUM CLEARANCES OTHER THAN ALCOVE OR CLOSET INSTALiATTONS.
• Minimum clearances to combustible surfaces: 2"clearance both sides and
3" rear.
MOBILE HOME INSTALLATION
• The dryer must be e.xhausted to the outdoors with the termination securely fastened to the
mobile home structure. (See EXH.\LST INFORMATfON section.)
• The exhaust ML'ST NOT be terminated beneath the mobile home.
• Provisions must be made for the introduction of outside air into the dryer. The free air
opiening shall not be less thji^SO cm* (12 in*)
• The exhaust duct material .ML’ST BE .METAL.
• The dryer must be attached to the floor following instructions a\ ailable from the dealer.
• Installation must comply with the current C.ANVCS.A Z240 MH series Mobile Home
Installation Codes.
NOTE: CO.N'SIDEILATIO.N .MUST BE GI\EN TO INST.UUING ANT) SERVICING THE
.■iJPLLAN'CE.
ELECTRICAL POWER SUPPLY
CALTION: .NEVER USE .AN EXTE.NS10N CORD WITH THIS APPLIANCE.
• This dryer must be connected to an individual circuit identical to the one specified on the
ratine plate of the loadine port, protected bv fuses or circuit breaker conformine to local
codes. THIS APPLIANCE .ML'ST BE PROPERLY GROL'NDED.
GROUNDING INSTRUCTIONS
• This appliance must be grounded. In the event of malfunction or breakdoun. grounding will
reduce the risk of eiectnc shock b> pro\ iding a path of least resistance for electric current.
The plug must be plugged into an appropriate outlet that Ls properl> installed and grounded
in accordance 'xith all local codes and ordinances.
WARNING:
• improper connection of the equipment grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or ser\‘iceman if you are in doubt as to whether the
appliance i.s properly grounded,
• Do not modify the plug pro\ ided with the appliance - if it wilt not fit the outlet, have a
proper outlet installed a uualiiied electrician.
Note: If the electrical pi'wer •'Upply provided dtx;s not meet the specifica[iün^ listed below,
------------- caiUüicea^cJ-elcctaáan.-----------------------------------------------------------------------------------------
> C ^ri ■. Ijr-,