Avanti D-24 - Manual (Page 8)

Installation Instructions
EXHAUST LENGTH CALCULATION
Table 1: RECOMMENDED MAXIMUM LENGTH
No. of W
dlbowi
ELECTRIC DRYERS
Weather Hood Type
Recommended L'se onlv for short run installations
*-«a''n0.!6cmi »-r2 [/2"(6.J5cml
Rigid Metallic Rexibie* Rigid Metallic Rexible*
14m(4brt.i
1 [m(38ft.)
9mi31 tt./
7miZ4t‘t. 1
9mi30ft.)
7Jmi25tt.)
bmtZOft.j
5 mi Ibft.t
1 lm{37ft.)
9m(30ft.)
6.5m(22ft.j
4.5m( 15ft.)
7m(24ft.)
6m(20ft.)
4m{ 14ft.)
3mt 10ft. I
Do not use non metallic flexible duct.
EXHAUST DIRECTIONS
All dryers shipped from the factory are set up for rear exhausting. However
e.xhausting can be on the right or left side of the cabinet or the bottom of the
dryer.
• Remove access panel at back of dryer to gain access to internal ducts.
• Disconnect duct exhaust from blower housing.
• Remove desired knockout place (either right or left side).
• Attach a 90“ elbow duct to blower housing and facing desired opening.
• Reinstall rear access panel.
Blower.
Left knockout
i Bottom knockout
Right knockout
EXHAUST DUCT LOCATING DIMENSIONS
NOTE: Non-metallic ducts must never be used inside dryer cabinet.