D-Link DES-2212 - Manual (Page 17)

Introduction 5
Hubs
Unlike 10BASE-T hubs, which are all functionally identical, Fast Ethernet
repeater hubs are divided into two distinct types: Class I and Class II. A
Class I hub repeats all incoming signals on one port to the other ports by first
translating them to digital signals and then retranslating them back to line
signals. These translations are necessary when connecting various network
media to the same collision domain, such as when combining two wire-pair
100BASE-TX media with four wire-pair 100BASE-T4 media. Only one
Class I hub can exist within the same collision domain, thus this type of hub
cannot be cascaded. A Class II repeater, on the other hand, immediately
repeats all incoming line signals on one port to the other ports; no translations
are performed. This type of hub connects identical media to the same
collision domain; for example, TX to TX. At most, two Class II hubs can
exist within the same collision domain. The cable used to cascade these hubs
is called an inter-repeater link (IRL).
As mentioned earlier, stackable hubs can be used to increase the number of
available nodes in a collision domain. An entire hub stack counts as a single
repeater.
Connectivity Rules
Fast Ethernet networks should respect the following limitations:
♦
The maximum length of a twisted-pair segment (that is, distance
between a port in the hub to a single-address network device such as a
PC, server, or LAN switch) is 100 meters.
♦
The maximum diameter in a collision domain is about 205 meters
using two Class II hubs and 200 meters using one Class I hub.
♦
Between any two end-stations in a collision domain, there may be up
to three segments and two Class II hubs or two segments and one
Class I hub.