Dacor IDWH24 - Manual (Page 18)

16
Before You Call for Service
Problem Solution Guide
Before you call for service, please review the Problem Solution Guide below.
Problem May Be Caused By What to Do
Flashing lights on
control panel
HEAVY, NORMAL, LIGHT,
QUICK and RINSE lights
flashing: Too much water in
dishwasher
Call for service.
LIGHT light flashing: Water
inlet problem
Make sure water valve is turned on. Make sure
water supply line to dishwasher is not kinked.
QUICK light flashing: Valve
leakage
Shut off water supply valve and call for service.
AUTO and HEAVY lights
flashing: blocked drain
Check for kinked drain hose. Disconnect end of
drain hose. Check for debris in hose or any other
part of drain system/plumbing. Check to see if filter
system is clogged (see below).
AUTO and NORMAL lights
flashing: clogged filter
Clean entire filter system. See page 13.
WASH TEMP and DRY cycle
lights flashing when a button is
pressed: child safety lock on
See page 11.
Dishwasher will not start
(control panel is not lit)
Main power switch is off Open door and turn on main power switch on top
of door before selecting cycle. See page 10.
Power is disconnected Make sure power is on at the circuit breaker panel
and that the power plug is properly connected to
electrical outlet (if applicable).
Blown fuse or tripped circuit
breaker
Replace fuse or reset circuit breaker. Remove
other appliances from circuit.
Power failure Contact electric company.
Dishwasher will not start
(control panel is lit)
Door not completely closed Gently push in on front of door until you hear a
click.
Controls not set Make sure dishwasher controls are properly set
and door is closed. See Page 10.
Child safety lock is engaged
( WASH TEMP and DRY cycle
lights flash when buttons are
pressed)
Disengage child safety lock. See page 11.
No water supply (delicate light
may flash on control panel)
Make sure water valve is turned on. Make sure
water supply line to dishwasher is not kinked.
Drain pump clogged (a loud
buzzing sound is heard, lights
on control panel may flash)
Disconnect power plug and clean entire filter
system. See page 13. Reconnect power and
attempt to restart. If problem persists, shut off the
water valve, disconnect power and call for service.
Overfilling/leakage Contact Dacor Customer Service.
Dishwasher has detected
a fault condition (lights on
control panel are flashing)
See Flashing lights on control panel above.