Ipod® playback – Denon AVR-2308 User Manual

Page 51

Get
ting Star

ted

Connections

Set
up

Remot

e Contr

Multi-Zone

Inf
or

mation

oubleshooting

ENGLISH

iPod® Playback

The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, sold separately).
The operation can also be performed using the buttons on the main
unit or remote control unit while watching the menus.

iPod is a trademark of Apple Computer, Inc., registered in
the U.S. and other countries.

The iPod may only be used to copy or play contents that are not

copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.

Make the necessary preparations.

Set the iPod in the DENON Control Dock for iPod.

(vSee the Control Dock for iPod’s operating instructions.)
w

Assign the Control Dock for iPod’s input.

MENU

: ”Input Setup” – “Assign” – ”iPod dock”

(vpage 35)

Either turn

or press

[iPod]

select the input source assigned in step 1-w above.

(iPod screen)

If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.

Set

[MODE SELECTOR 1]

to “AUDIO” and

[MODE

SELECTOR 2]

to “iPod/NETWORK”.

(vpage 51 “Remote Control Unit Operations”)

OK to disconnect.

Basic Operation

NOTE

• Depending on the type of iPod and the software version, some

functions may not operate.

• DENON will accept no responsibility whatsoever for any loss of iPod

data.

• With the default settings, the iPod can be used connected to the VCR

(iPod) connector.

• Use the RESTORER mode to expand the low and high frequency

components of compressed audio fi les and achieve a richer sound.
The default setting is “Mode3”.

• Press and set the AVR-2308’s power to the standby

mode before disconnecting the iPod. Also switch the input source
to one to which the menu “iPod dock” is not assigned before
disconnecting the iPod.

Either turn

or press

[TUNER]

select “TUNER”.

Set

[MODE SELECTOR 1]

to “AUDIO”.

(vpage 51 “Remote Control Unit Operations”)

Press

While receiving an RDS broadcast station, the text data broadcast

from the station is displayed.

To turn the display off, press .

If no text data is being broadcast, “NO TEXT DATA” is displayed.

RT (Radio Text)

“RT” appears on the display when radio text data is
received.

Pla
ybac