Datalogic Scanning Jet - Manual (Page 54)

DATALOGIC JET™
3
Default Settings
The following tables contain the default values for the major barcode setup
parameters, according to the type of scan engine mounted on the PDA. For a
complete list of parameters and of their configuration procedures, please refer to the
SDK Help file on the CD.
SCAN PARAMETERS HP Laser Imager RFID+Laser
ScanTimeout 5000 Not available 5000
GoodReadSound Beep.wav Beep.wav Beep.wav
LedDuration 200 ms 200 ms 200 ms
LedPulses 1 1 1
ContinuousMode Disabled Disabled Disabled
KeyboardEmulation Disabled Disabled Disabled
SoftTrigger Enabled Enabled Enabled
ScanAlwaysOn Disabled Disabled Disabled
NotPrintableChar Leave Leave Leave
BARCODE SYMBOLOGY
SPECIFIC
READER PARAMETERS
HP Laser Imager RFID+Laser
UPC A Enabled Enabled
UPC E Enabled Enabled
EAN 8 Enabled Enabled
EAN 13 Enabled
*
Enabled
UPC E1 Disabled
EAN Bookland Disabled
UPC/EAN/JAN Enabled
Code 39 Enabled Enabled Enabled
Code 39 Full ASCII Disabled Disabled Disabled
Code 32 Disabled Disabled
Code 39 Trioptic Disabled
2/5: Interleaved Enabled Enabled Enabled
2/5: Industrial Disabled Disabled
2/5: Matrix Disabled
Code 128 Enabled Enabled Enabled
EAN 128 Enabled Disabled Enabled
ISBT 128 Disabled
Codabar Enabled Enabled Disabled
RSS Disabled
* In the Imager models these codes may only be enabled or disabled as a group by the
UPC/EAN/JAN family selection (see a few lines below).
38