Zanussi Z 300 CDP - Manual (Page 10)

Bedienung/Handgriffe Installation GB
Flusensieb reinigen (Abb. 7).
Das in der Türinnenseite befindliche Fiusensieb
muß unbedingt nach jedem Trocknen gereinigt
werden,
Sieb an seinem Griff nach oben herausziehen,
reinigen und wieder einsetzen.
Abb. 7
Fiusensieb
Kondensatbehäiter entieeren (Abb. 8), (ist auch
während des Programmablaufs möglich).
Das der Wäsche entzogene Wasser wird innerhalb
des Trockners kondensiert und im Kondensat­
behäiter aufgefangen.
Der Kondensatbehälter muß nach jedem Trocknen
entleert werden, damit auch im darauffolgenden
Programm die Wäsche einwandfrei getrocknet
wird.
Wird das Entieeren vergessen, spricht die Über­
laufsicherung an. Die Signaiiampe »Kondensat«
in der Bedienbiende leuchtet auf, das Programm
wird automatisch unterbrochen, die Wäsche ist
noch naß.
Abb. 8
Behälter wieder ganz einschieben.
Tip:
Das aufgefangene Kondenswasser kann für das
Dampfbügeieisen verwendet werden. Dazu Kon­
denswasser filtern (z. B. über Kaffeefilter).
This tumble dryer can be installed without any
special expenditure or special equipment, though
the instructions given below and where necessary
the regulations of the competent electricity supplier
must be noted during installation and connection of
the appliance.
The tumble dryer can be installed on any level floor.
It must stand horizontally, i. e. possibly be aligned
with the aid of a spirit-level. Through adjustment of
the height-adjustable feet, uneven floor conditions
can be compensated. To assure trouble-free ope­
ration of the tumble dryer, a good continuous air
supply and hot air discharge through the venting
slots located in the plinth at the front of the tumble
dryer must be available.
Do not remove the height-adjustable feet. The
tumble dryer should not be installed on long-pile
carpets or the freedom on the floor around it reststric-
ted by strips and the like. This could lead to a build-up
of heat which could impair operation of the motor or
even damage it.
Important note :
■ The hot air discharged from the tumble dryer
may reach a temperature of 60°C. This should
be noted if your tumble dryer is installed on
sensitive carpeted floors.
■ The room temperature should not exceed -l-35°C
during operation, otherwise open door or
window.
■ The space around the tumble dryer must be
kept free of lint.
Building-under
The appliance can also be integrated in fitted kitchens
or installed as a build-under unit after removal of
the worktop.
For this purpose, please note the following:
■ Unplug the appliance.
■ Unscrew the mounting screws at the rear of the
appliance (Fig. 2).
■ Pull the worktop back and lift it.
If the worktop is removed for incorporation of the
appliance in kitchen furniture runs, installation must
be accomplished in such a manner that neither
live parts nor operationally insulated lines are
accessible.
Protection against access to live parts, etc. after
removal of the appliance worktop is assured by
appropriate arrangement of a cover sheet. The cover
sheet can be ordered from the service centre.
To ensure that the splash protection is retained,
foam sealing strips are to be stuck or arranged
around the whole periphery of the cover sheet.
Fig. 2
10 43