Dayton 3VG79 - Manual (Page 9)

Dayton Operating Instructions and Parts Manual
9
Model 3VG79
Version B - For Reduction G016.J
®
Sandpaper
Gap Adjusting Screw
Gap Adjusting Screw
.003"/.004" Gap
Measured With
Feeler Gauge
Rotor
Blade
5. Remove pump plate.
6. Remove rotor, insert, and blades.
7. Check for debris in pump. If debris is
found, blow out with compressed air.
8. Install insert and rotor.
9. Check gap on rotor. Adjust to
.003"/.004" if needed (See Figure 19).
NOTE: Rotate rotor one full turn to insure
the gap is .003"/.004" at tightest position.
Adjust if needed.
10. Install blades, pump plate, air filters,
and filter end cover.
Figure 19 - Gap Adjusting Screw Locations
Figure 20 - Sanding Rotor
STORING, TRANSPORTING, OR SHIP-
PING
NOTE: If shipping, transport companies
require fuel tanks to be empty.
1. Drain fuel tank.
NOTE: This model has a drain plug on
underside of fuel tank. Remove drain plug
to drain all fuel. Be sure all fuel is removed.
2. Replace drain plug.
3. If any debris is noted in old fuel, add 1
or 2 quarts of clean kerosene to tank,
stir, and drain again. This will prevent
excess debris from clogging filters
during future use.
4. Replace fuel cap and drain plug.
Properly dispose of old and dirty fuel.
Check with local automotive service
stations that recycle oil.
5. If storing, store heater in dry place.
Make sure storage place is free of dust
and corrosive fumes.
IMPORTANT: Do not store kerosene over
summer months for use during next
heating season. Using old fuel could
damage heater.
Never service heater while it is plugged in, operating, or hot. Severe burns and electrical shock can
occur.
Preventative Maintenance Schedule
Fuel tank Flush every 150-200 hours of operation or as needed. See Storing, Transporting, or Shipping,
above.
Air output and Replace every 500 hours of operation or once a year. See Air Output, Air Intake, and Lint
lint filters Filters, page 6.
Air intake filter Wash and dry with soap and water every 500 hours of See Air Output, Air Intake, and Lint
operation or as needed. Filters, page 6.
Fuel filter Clean twice a heating season or as needed. See Fuel Filter, page 7.
Spark plug Clean and regap every 600 hours operation or replace as needed. See Spark Plug, page 7.
Fan blades Clean every season or as needed. See Fan, page 6.
Motor Not required/permanently lubricated.
How Often How To Item
11. Replace fan guard and upper shell.
12. Adjust pump pressure (See page 16).
NOTE: If rotor is still binding, proceed as
follows.
13. Perform steps 1 through 6 above.
14. Place fine grade sandpaper (600 grit)
on flat surface. Sand rotor lightly in
“figure 8” motion four times (See
Figure 19).
15. Reinstall insert and rotor.
16. Perform steps 10 through 12 above.
Maintenance (Continued)