ASKO 7003 - Manual (Page 5)

If you want to check how
dry washing is:
Open the door.
The drum stops automatically
and will not restart until you
close the door and press
the Start pushbutton.
If the machine
does not work
The machine will not start
Check that:
•The front door is properly closed.
•The main On/Off pushbutton is
pressed in.
•The electric plug is firmly inserted in
its socket (if the machine is not
permanently wired in).
•Aii fuses are intact.
NOTEi
If the machine still fails to start, it is
probable that the overheating cutout
has operated. It switches off the
tumbler if the temperature is too high.
For example if dust has blocked the
lint filter. Clean the filter and reset the
overheating protection switch by
pressing the rubber disc on the back
of the machine.
When the dryer has stopped:
• Remove the washing
• Clean the lint filter
•
Turn off the power at the
main On/Off pushbutton
switch
The machine starts, but
will not continue to run
If the machine starts when the Start
button is pressed, but stops as soon
as the button is released, it indicates
that the overheating cutout has
operated. Clean the lint filter and
allow the machine to cool down.
Excessive drying times
Check that the lint filter is not block­
ed. Do not overload the dryer. Items
to be tumble-dried must first have
been spin-dried, preferably at 800
r/min or more
Note!
Clean lint collecting near the
tumble dryer as it can be sucked
into the air intake.
Cleaning
the lint filter
The lint filter must be cleaned after
each time the machine has been
used. If this is not done, drying
performance will suffer, as insuffi­
cient air will pass through the drum.
The machine may also overheat: this
will cause it to stop automatically.
Clean the filter as follows:
© Grasp the filter holder by the two
holes near the center and pull it
off the peg on which it is
supported in the front door.
Take the filter out of the holder
and brush away the lint in it by
hand.
NOTE: Wear and tear of fabrics in a
tumble dryer is insignificant.
The lint caught in the lint
filter is dust and fiber
residue that has been
formed when the garments
have been used.
Replace the filter in the holder
and refit the holder in position on
the peg in the door.
Other user service
About once a year, remove the
flexible exhaust air hose and clean it
and the outlet from the machina