The motor protection is schvated, The fuse blow« or hips, The thread«ollecldrs are urom out – AEG VAMPYR 731I User Manual
Page 12: What to do wfim
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
What to do wfim...
... the motor protection Is scHvated?
When ttie paper-dustbag is full or blocked or any of the accessories are blocked the
ovar-heating protectioptorthe motor isactivated. Switch oH and unplug the vacuum
cleaner and allow the motor to cool down.
Check the paper dustbag and accessories and remove any blockages. The cleaner
can be switched on again after 30 minutes.
... the fuse blow« or hips?
If you connect other electrical appliances with a high wattage to the same mains cir
cuit and use them at the same time as the vacuum cleaner, this can trip the fuse.
This can be avoided if you set the electronic power control to 250W before you
switch on, and only select a higher output level after switching on.
3
. the thread«olleclDrs are urom out?
If the thread-collectors at the suction opening
are worn out or stuck together, you can fit ones.
They can be ordered trom the AEG Service Centre
under the ET-No; 668 900 560.
...№e wheels of the floor cleaning head are
hard to move?
Remove any hairs or threads which have become
wrapped round the axle of the roller. The wheels
can be removed for cleaning. Pull roller (A) as illus
trated. Remove hairs and threads. When replacing
it, the semi-circular axle-head must point inwards. If the roller axie is inserted wrong
way round the swivel joint could suffer damage.
3
a
a
26