Audiovox MP4000 - Manual

Sten General Infermation
Abeut Year Player
CO
.I Box Contents.
o r » ñ
2 Accossorlos
Cigarette Adapter Coiled Cable Min r'Jin
.3 Player Car Installation
There are several ways to connect your Player to your Car. The Player comes with a Cassette
Adapter to deliver the audio to your car stereo. Optionai RF Moduiators and FM Transmitters
can be purchased so your MP3s can be heard through your car stereo FM tuner. For powering
and mounting your Player in your car, you are suppiied with a Cigarette Power Adapter,
Windshieid Mount, and Veicro.
The Car Power Adapter has two pieces.
The first is the head unit that piugs directiy
into your car cigarette lighter. A coiled
cable is provided that plugs into the head
unit. The other end of the cable is plugged
directly into the "dc in" port on the Player.
Insert Into "dc In" port
Car Power Adapter
Player Car instaiiatinn
□
I. Insert the stereo plug of the cassette adapter into the headphone jack of the Player.
C.
Insert the cassette adapter into your car’s cassette tape player.
Position the windshield mount and apply pressure to allow the suction cups to secure firmly.
Audiovox recommends placement in the center of the windshield to keep from obstructing
your view while driving.
Align the mounting slot in the rear of the Player with the windshield mount and slide on until
the unit snaps into place. There is a small button on the rear left side of the Player that when
pressed will release the Player from the windshield mount - hold down release button while
removing Player from the bracket.
If the mounting angle of the Player is not adequate, remove the mount from the windshield
and gently bend the metal of the mount to improve the angle on the windshield.
You are now ready to use your MP3J. Audiovox recommends that you set the Player volume at W and use the car radio
volume control for the best sound. Experiment and find the best setdngs for you.
5 Important Safety Information & Warranty
A
ATTENTION: This symbol is intended to alert the user to the
presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
Read Instructions: All the safety and operating Instructions should be read before the
product is operated.
Retain Instructions: The safety and operating instructions should be retained for future
Heed Warnings; All warnings on the product and in the operating Instructions should be adhered
to.
Follow Instructions; All operating and use instructions should be followed.
Water and Moisture: Do not use this product near water - for example, near a bathtub, wash bowl,
kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like.
Object & Liquid Entry; Never push objects of any kind into this product through openings as they
may touch dangerous voltage points or short-out parts that could result in a fire or electric shock.
Never spill liquid of any kind on the product.
Servicing; Do not attempt to service this product yourself as opening or removing covers
may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service
professional.
Heat;The product should be situated away from heat sources such as radiators, heat registers,
stoves, or other products that produce heat
Certification Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference In a residential installation. This equipment generates, uses and radiates radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the Interference by one or more of
the following measures;
1. Reorient or relocate the receiving antenna (television, radio, etc.)
2. Increase the separation between the equipment and receiver.
3. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for additional help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. Contact Audiovox Electronics Corporation, '150 Marcus Blvd.
Hauppauge, NY 11788. Telephone: 631 -231 -7750. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions; (1) this device may not cause harmful interference, and
(2) this device must accept any Interference received. Including interference that may cai
Contact Information & Tradomarking
For More Information, please contact:
Customer Support: toll free in the US: (800) 229-1235 or visit www.audiovox.com
l2Go™, "Internet To Go"™, "Interact Button"™ and MP3Agent™ are all trademarks of i2Go.com and are protected under US
and foreign trademark restrictions. All other product and brand names referenced in this manual or at www.i2Go.com may be
service marks, trademarks, or registered trademarks of their respective manufacturers. i2Go.com reserves the right to change
specifications without notice. Copyright ©1999, 2000 l2Go.com, Inc. All rights reserved.
AUDIOTOX
C O R P O R A T I O N
Audiovox Corporation
150 Marcus Bivd.
Hauppauge, NY 11788
Phone: 631-231-7750
Toli free in US: 800-260-6650
Fax: 781-935-5479
or 781-933-1650
Getting Staned...
I
S^AUDIQTQX
Qtsan
Using your Interacdve
Digital Audio Playerl
C/3
1.1 On the Mark: installing the hatteries
Make sure the batteries are installed in the correct
position as shown:
* Batteries Not Included - (2) AA Required
1.2 Get Set: Insert the
Insert the Microdrive into the back
of the Piayer. The drive must be inserted with
the IBM Microdrive iabei facing toward the bottom of
the Piayer and the barcode on the Microdrive facing
up. Once the Microdrive is fuiiy inserted, secure
safety iatch by foiding the iatch to the side.
o
iBM Microdrive
(barcode side up)
Do NOT remove the IBM Microdrive until you power off the Pleyer.
1.3 Go: Power Up
Press and hoid the "Power" button untii the Piayer
powers up. On the dispiay, you wiii see "Heiio".
When running on batteries, if ieft on, the dispiay wiii
go into power save mode. Tap the "Power" button to
wake up the dispiay.
Power
Time to Play:
Push the "Piay/Pause" button to piay any audio
content downioaded to the IBM Microdrive.
The fiiename wiii appear on the dispiay.
You can push the "Piay/Pause" button to pause
piayback. To navigate between MP3 fiies, press the
"FF" and "REW" buttons to iisten to the next or
previous MP3 fiie.
*You can load or delete audio content to the microdrive from your
computer using the MP3Agent once you have completed the installation
instructions that follow.
Play / Pause
1.5 Finishing Tenches: Adinst the Voinme
Page 5, Continue to Page 6 o Pages
Adjust the volume using the "+" and buttons.
Paget, Continue to Page 2
d