Directed Video DV1700 - Manual (Page 20)

20 © 2003 Directed Electronics, Inc.
CONNECTING TO A STEREO TV
BASIC CONNECTION
■ Do not block ventilation holes of the DVD
player and arrange it so air can circulate
freely.
■ Read these instructions thoroughly before
connecting audio and video cables.
■ Ensure that you observe the color coding
when connecting audio and video cables.
REMOTE CONTROL
To install the external remote sensor, simply plug
it into the REMOTE IN socket located at the rear
of the DVD and route the sensor cable to the
front of the vehicle, mount the sensor in a con-
venient location so that the remote control is in
the line of sight of the external remote sensor.
■ Before installing the unit, connect the
wiring temporarily and test the system for
proper operation.
■ Use only the parts included with the unit
to ensure proper installation. The use of
unauthorized parts can cause malfunc-
tions. Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
■ Install the unit where it does not get in
the driver's way and cannot injure the pas-
senger if there is a sudden or emergency
stop. For optimum performance, this unit
should NOT be mounted at an angle of
more than 5 degrees from horizontal.
■ Avoid installing the unit where it would be
subject to high temperature, such as direct
sunlight, hot air from the heater, or where
it would be subject to dust, dirt, or
excessive vibration.
NOTE: Do not mount the unit where it will be stepped on
or where items will be placed on top of or spilled
into the unit.
MOUNTING THE UNIT
This unit can be mounted either under a cabinet
or under a seat by using the brackets supplied in
the kit. Attach the mounting brackets as shown
in the drawing below according to the final
mounting position of the player.
If mounting the player under a seat, attach the
brackets using the bottom holes. This will allow
the player sufficient ventilation for proper oper-
ation and avoid moisture collection that may
cause moisture collection.
Always mount the player to a solid location to
avoid possible vibration and shock.
Installation
N83102 1-03.qxd 5/6/2003 8:33 AM Page 20