Avanti 18EYC - Manual (Page 9)

> Reversal And Installation Of The Refrigerator Doorf498YC/YW/YB/YSS)
• Remove the two screws(1)that hold the lower hinge(2)(right side)to the
frame. Also, remove the screw-type ieveiing front leg(3).
• Remove the left front leg(4) and transfer it to the right side.
• Lift the door and place it on a padded surface to prevent scratching it.
Make sure to remove the spring(5) located inside the upper right hole
of the door and the upper right side pin(6).
• Remove the plug button(7)from the upper left hole of the door and
transfer it to the uncovered hole at the right side. Be sure to press the
button firmly into the hole.
• Insert the upper pin(6) previously removed from the right side (step 3)
and transfer it to the other hole at the left side of the top frame.
• Insert the spring(5)previousiy removed{step 3)inside the upper left side
hole of the door.
• Set the door to its place making sure the pin{6)enters the bushing at
the lower upper frame section(hole).
• While holding the door in the closed position, secure the lower left
hinge(2)previously removed(step 1).Before placing this lower hinge,
remove the upper bolt'pin(8) and reverse the direction of the hinge.
• Insert the bolt-pin(8)and do not tighten until the top of the door is
leveled with the counter top.
• Insert the two screws(1)previously removed{step 1)and tighten them.
FIGURE 1 (Position
prior to door reversal)
FIGURE 2(Position
after door reversal)
(D Door Hinge Screws
(D Lower Door Hinge
(1) Front Leveling Legs
® Left Front Leg
(D Door Frame Spring
d) Door Frame Pin
® Hinge Plug(Door Frame)Left Side
CD Door Hinge Bolt
-8 -