AEG VAMPYR 825I - Manual (Page 12)

Transportation and storage
For easier storage and for transporting the appli­
ance, slide the floor cleaning head or the
ROTOSOFT1000 Turbo-brush into the storage rail.
What to do when.
...the motor protection is activated?
When the paper dustbag is full or blocked or any of the accessories are blocked the
over-heating protection for the motor is activated. Switch off and unplug the vacuum
cleaner and allow the motor to cool down.
Check the paper dustbag and accessories and remove any blockages. The cleaner
can be switched on again after 30 minutes.
£
CD
... the fuse biows or trips?
If you connect other electrical appliances with a high wattage to the same mains cir­
cuit and use them at the same time as the vacuum cleaner, this can trip the fuse.
This can be avoided if you set the electronifi power control to 250 W before you
switch on, and only select a higher output level after switching on.
0
... the thread-coilectors are worn out?
If the thread-collectors (B) at the suction opening
are worn out or stuck together, you can fit ones.
They can be ordered from the AEG Service Centre
under the ET-No. 668 900 560.
...the wheels of the floor cieaning head are
hard to move?
Remove any hairs or threads which have become
wrapped round the axle of the roller. The wheels
can be removed for cleaning. Pull roller (A) as illus­
trated. Remove hairs and threads. When replacing
it, the semi-circular axle-head must point inwards. If the roller axle is inserted wrong
way round the swivel joint could suffer damage.
£
O
26