Aiwa CDC-X145 - Manual (Page 8)

PRESEUING STATIONS
To preset stations manually
1
2
3
4
Press PWR to turn the unit on.
Press BAND to select the band from
among FM1, FM2, FM3, AMI, and AM2.
Tune in the station that you wish to
preset with TUNE or TUNE
Press one of the preset station buttons
1 to 6 for approximately 2 seconds.
While the station you are presetting is being
registered in memory, the sound is
momentarily muted.
The number of the pressed preset station
button appears next to the frequency
indication.
I....... yfMij.ia
I .3 IPS. I
Preset number
Repeat these procedures to preset up to 6 stations
each for FM1. FM2. FM3, AM1, and AM2.
• You can manually preset stations that have not
been selected by auto memory.
• If you try to preset a station on a preset station
button on which another station of the same
band has already been preset, the previously
preset station will be erased.
To tune In the preset stations
1
1 Press PWR to turn the unit on.
2 Press BAND to select a desired band
from among FM1, FM2, FM3, AM1, and
AM2.
3 Press the desired preset station button.
The number of the pressed preset station
button appears next to the frequency
indication.
Active tuning reception control (ATRC)
This unit automatically suppresses FM noise
caused by varying signal strength resulting from
movement of the car.
• The built-in automatic blending circuit mixes the
left and right channel signals according to the
strength of the reception. At the same time, the
high-cut circuit activates to maintain the sound
quality.
• If the reception becomes even weaker, the unit
automatically switches to Monaural mode to
reduce noise.
7 enGUSH