AEG OKO_FAVORIT 3220 - Manual (Page 34)

шшштммёшшмтй
3 4
Setting Up:
The dishwasher must be positioned on a solid horizontal base. The feet of the
appliance can be adjusted by approx. 5 cm. This allows:
- uneven floors to be compensated for
- the height to be adjusted to match other furniture
If you are installing the dishwasher underneath a kitchen worksurface please
note the following points:
- sufficient space must be allowed for at the rear of the appliance to accommo­
date the drain hose, iniet hose and mains cable. They must not be kinked or
jammed behind the appliance,
- with integrated and decor fronted build-under appliances, please ensure that
the appliance is attached to the underneath of the kitchen worksurface or to an
adjacent unit. This is essential in order to ensure that it will not accidentally tip
forward.
Depending on the type of installation, the following installation procedure must
be followed:
Integrated Appliances (i models)
For installation see installation template provided.
Important! The appliance door can be lined with a wood panel/furniture panel
of the following dimensions:
Width:
591 mm - 594 mm
Thickness: 16 mm - 24 mm-
Height: depending on:
- recess height
- plinth height
- matchup to the joint runs of adjacent furniture (e.g. drawer), though
max. 600 mm
Important Note! Should the furniture panel be longer than 600 mm, the appli­
ance door cannot be fully opened (the furniture panel bumps against the plinth),
In this case the plinth must be cut out (see installation template) or overlength
door hinge kit BLT 60 used. You can obtain this under E-No. 911239008.
Build-under (U models) and Build-In (E models) Appliances
For installation see installation instructions provided.
Freestanding Appliances
□ Freestanding appliances do not need to be secured to adjacent furniture.
Note: (only applicable to freestanding appliances fitted with original worktop).
If the dishwasher needs to be installed directly next to a heat source such as a
cooker or water heater, an insulation plate must be positioned to protect the side
of the worktop {depth 57.5 cm). The insulation plate should have aluminium foil
&
0