AEG OKO_FAVORIT 3220 - Manual (Page 29)

Please check whether you can solve the smaller problems with the machine your­
self, by means of the following advice. If the advice does not help, please contact
the AÉG Customer Service Department.
□ Drainage pump continually running • even when the machine is turned off.
- The flood protection system has activated. First, close the water tap, then pull­
out the plug. In case of hard-wiring: turn off the electricity supply, remove the
fuse and disconnect. Telephone the AEG Customer Service Department to reg­
ister the fault.
□ The programme does not start.
- Are the electrical fuses in good order? Is the machine connected to the mains?
- Is the door closed properly?
□ The machine is not taking water in.
- Is the water tap open?
- Is the mesh in the pipe connection at the water tap blocked? If necessary, ciean
mesh.
- Is the water inlet hose kinked? Check pipe connection. (See section “Connec­
tion")
□ Programme progress display remains at the Start position.
- Is the water tap fully open?
- Is the filter in the pipe connection to the water tap blocked? If necessary, clean-
filter.
- is minimum water pressure of 1 bar available? (See section "Connection”)
□ The dishes are not being cleaned.
- have you selected a programme which is suitable for the type of dishes and their
level of soilage? (See section "Programme Guide")
- have you loaded the dishes so that the water spray reaches all the items? The
crockery baskets should not be overloaded (See section “Loading the Dishes”)
- Were the spray arms blocked by crockery or cutlery?
- Please note: the upper spray arm tilts when not in use. This allows all the water to
drip out of the spray arm. In operation, it automatically runs in a horizontal posi­
tion.
- Are all filters in the filter assembly clean? Are all the filters correctly set up? (See
section "Cleaning the filters")
- Have you added the correct amount of detergent? (See section "Refilling Dish­
washer Detergent”)
- Is the drainage pipe correctly laid out? (See section "Connection")
- Is there still salt in the salt container? Without salt, the water is not softened.
Water hardness greater than 4° Clarke can lead to lime formation on the dishes
(See section "Refilling Salt”).
29