Audiovox AV-970 - Manual (Page 10)

GHinSLER-DODGE-PLTMOUTHIIISTAU.ATION
ALL U.S. MADE CARS, TRUCKS, AND VANS BUILT SINCE 1974
important-This fadio cannot be installed in any U.S. made Chrysler, Dodge, or Ptyrnouth vehicle without an
instaliation kit. Refer to Ihe Kit Listing on Page 2 lor the required kit. Compiete kit installation is explained in the
instructions included with the kit.
^ . Натпв Extsting Radio:
A- Remove the existing dashboard trimpanei surrounding the radio opening. This panel is usually secured by
screws and/or snap-in clips,
B. Remove the two large screws used to secure radio to the sub-dashboard,
G. Pull Ihe radio forward to access the wiring and antenna cables plugged into the near of the chassis.
D. Un-plug the wiring hamessies) and antenna cable and remove the radio,
2. ■■■taJItfeelewfladli:
A. follow Ihe instructions included with the installation kit to attach the radio to the mourning plate supplied with
the kit.
B, Place the radio near ihe dashboard so the wires can be led through the opening and fallowing Ihe Instructions
of Step 2 on Page 3. carefully wire the radio making certain all connscliorys are secure ar>d insulated and
conlirm proper operation.
C- Install the radio/mounting plate assembly to the suhHdashboard according to instructions of instalEalion kit.
D. Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut
provided. Fasten the olherend of the perforated strap to a secure partof the dashboard either above or below
the radio using the screw and nut provided. Bend the strap to position it ss necessary.
CAUTION: The rear of the radio must be supported with Ihe strap lo prevent damage to the dashboard from the
weight of the radio or improper operation of the radio due to vibration.
E. Replace the dashboard trimpanei.
F. Install knobs on radio shafts.