Dixon 13089-0601 - Manual (Page 14)

14
SPECIFICATIONS
Model ZTR 5023
CHASSIS: 11 GA - rectangular tube
BODY: Two piece - made of high-density polyethylene. Front body contains
access panels for battery service and engine to mower deck belt
removal. Rear body tilts up to allow service on the entire drive
system.
SEAT: Designed for operator comfort by use of high density closed cell
foam padded back and arm rests, upholstered with Cordura
TM
water-repellent fabric. Seat is adjustable fore and aft.
MOWER DECK: Two decks are available. The 60" is made of stamped steel. The
50" is made of 11 GA fabricated welded construction with external
reinforcement ribs. Three blades combine for a 50" or 60" cut
width. Cut height approximately 1.5" to 4.5" via 7 position lift
handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L
Series 70 hydrostatic transmission.The hydrostatic
transmissions, in turn, power a fully enclosed HydroGear gearbox.
ENGINE: 23HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve,
Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head, and Crankcase
with Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter,
Pulse-type Fuel Pump, Fixed Jet Carburetor w/Smart-Choke,
Electronic Ignition, In-Line Fuel Filter, Dual Element Air Cleaner.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking
brake and blade drive clutch.
TIRES: Front 11 X 4-5 Ribbed Tread
Rear 20 X 10-8 Multi Trac
RECOMMENDED Front 16 - 21 lbs.
TIRE PRESSURE: Rear 8 - 14 lbs.
CAPACITIES: Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS: Width 60"(50" Deck), 72"(60" Deck)
Height 45"
Length 72"
Weight 680 lbs.(50" Deck), 685 lbs.(60" Deck)
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION