Arcam 9 - Manual (Page 4)

Using your CD player - getting started
continued
H toack H - power .
DISPLAY
Dims or turns the display off and on. Turning the display off will
generally give a slight improvement in sound quality. Pressing
'DISPLJ^Y' once turns the display off To dim the display press the
‘DISPUW button twice. To restore the display to full brightness
press ‘DISPLAY’ a third time.
REPEAT
To repeat the entire CD or a pre-programmed selection of tracks
press 'REPEAT once. 'REPEAT will illuminate on the display.
To repeat one particular track go to the track you wish to repeat
by using the H or H buttons (or the 0-9 keypad on the
remote control) and press 'PLAY'. Then press the REPEAT button
twice so that 'REPEAT I ’ is illuminated on the display.
If you now select a different track, that one will be repeated
instead. To cancel the repeat function press 'REPEAT' a third time.
PROG
To programme a selection of up to 24 tracks from a disc in any
order To program your choice of tracks press Track H or H .
or use the remote's 0-9 keypad orTrack |-^ and
H buttons, to locate the desired track.
Press 'PROG' to program the track into memory (RMS is illuminat­
ed on the display to indicate that you have begun a programmed
sequence). Repeat these steps to
program all the desired tracks into the player The display will
show the track numbers that have been programmed, the total
length of the programmed sequence and how many tracks have
been programmed by use of the number above the word 'STEP'.
If you press |-< or H or use the 0-9 keypad to direct dial to a
track the number above the 'STEP' will change by one and start to
flash until you press 'PROG'. After pressing 'PROG' the number
will stop flashing. If you fail to press 'PROG' within about 5
seconds the display will also stop flashing and you will have to
reselect the track you want to program.
Press 'PLAY' to start playback of the programmed tracks.
The existing program may be replayed by pressing'PLAY'.
To dear the programmed sequence of tracks press STOP twice.
CHECK
To confirm your programmed sequence, press'CHECK'.
The first programmed track number and track time will be
displayed. Subsequent pressing of the 'CHECK' button will display
the next track details and total time of the sequence so far
After checking the last selection ‘END’ is displayed for a few
seconds. The display then reverts to showing the track details of
the last programmed track