Arcam 9 - Manual (Page 3)

Using your CD player - getting started
o
-h« trach : H ^ .POWER
o o o
LO«) PLÀY STOP ."PÀUSE * DISPLAY REPEAT CHECK o o o'o .© o ,o
o
■ : H TRACK H POWER
o o o o
o o o o o o
POWER
Press this button to switch the CD player on and offi
When first powered up with no CD installed you will see...
...first this ...then this
LOAD (called OPEN on remote control)
To install a CD, press ‘LOAD’. The CD tray opens, it accepts both
8 cm and 12 cm discs. Place the CD in the tray with the label side
uppermost. Press 'LOAD' again [or press ‘PLAT’, or gently push the
tray in 5mm], the tray closes, You will see 'DISC, along with the
total number of tracks and total disc time, eg.
C D T O
D C . I D
If the disc has rrfore than 16 tracks then the word 'OVER' is also
shown on the display. The display returns to '0' after a few
seconds. It is now ready to play.
PLAY ►
Press to play the CD. To restart the disc from track I, press 'STOP'
and then ‘PDW.
Note:
Make sure your amplifier (input source selector) is set to CD.
HDCD encoded CDs will be recognised automatically by the
Alpha 8SE and 9CD players.To indicate this, a red LED (Light
Emitting Diode) will illuminate behind the Arcam badge in the top
left hand corner of the front panel whenever an HDCD disc is
playing.
STOP ■
Press to stop the CD playing.
The display will show an '0' and the number of tracks.
PAUSE II
Press to pause the disc (interrupt play).
Press 'PAUSE' again to resume play from the same point.
o o o o o o
SEARCH MM ►►
Press MM to search back or ►►to search forward, for a particular
passage during play. If the player is in 'PAUSE' mode the search will
be at high speed and the sound will be muted (you will hear
nothing).
TRACK - PREVIOUS or NEXT H H
To start the CD with a track other than the first one, press H
or 1-^ to locate your desired track, then press'PLAY',
To select another track during play, press or H to locate the
track. The player will automatically'PD\Y'after you have selected
the track. Pressing \ m once will restart the track currently playing.
To select the previous track, press \ m twice. To go back two
tracks, press |^ three times, and so on.