Arcam 9 - Manual (Page 2)

Thank you for choosing ARCAM
USING THIS HANDBOOK
This handbook has been designed to make the installation and use
of your CD player straightforward. However; we appreciate that
some of our customers require further technical information.
When extra technical information is available you will see the
following, at the end of the section: [Want more info? See Technical
notes on page 5]
SAFETY
There are 18 safety items, set out on the back cover of this
handbook. For your own safety, and to ensure that your CD player
works properly, we strongly recommend that you read them.
SEVERAL MODELS
This handbook covers four CD players:
Alpha 7
Alpha 8
Alpha 8SE
Alpha 9
Many features are common to more than one of these CD players.
[Want more info? See no. I in Technical notes on page 5]
There is a remote control handset supplied.
Installation
CONNECTING TO A POWER SUPPLY
WRONG PLUG :
If the plug supplied with the amplifier does not fit your power
supply see no. 3 in Technical notes on page 5.
Check that your mains supply voltage agrees with the voltage
setting indicated above the POWER INLET on the rear panel of
the CD player
CONNECTING TO OTHER EQUIPMENT
DIGITAL OUTPUT
Use this socket if you are using a separate digital to analogue
converter (DAC) or digital recorder Connect to the DAC or
recorder’s digital input using a suitable 75 ohm screened cable.
Never connect the digital output socket to a conventional audio
input.
If your mains supply voltage is different, consult your Arcam dealer
or Arcam Customer Support on +44 (0) 1223 203203.
PLUGGING IN
Push the plug (lEC line socket) of the cable supplied with the CD
player; into the socket (POWER INLET) in the back of the CD
player Make sure it is pushed in firmly.
[Want more info? See no. 2 in Technical notes on page 5]
Push the plug on other end of the cable into your power
supply socket.
The CD Player is double insulated and does not require an earth.
This is why there is no centre(earth) pin in the socket (POWER
INLET).
AUDIO OUTPUTS
Connect to your amplifier’s CD orAUX inputs using suitable high
quality interconnect cables. Insert the phono plug which is red [or
marked ‘R’, or with a red ring] into the socket labelled 'R' and the
other plug into the socket labelled 'L.
ALPHA 8, 8SE & 9 ONLYThe second set of sockets can be used
to connect to a second amplifier set up for multi room use.
Note
Interconnecting cables are not supplied with this CD Player
We recommend high quality cables as inferior quality cables
will degrade the sound quality of your system. Please contact
your Arcam dealer or Arcam customer support for details of
suitable cables.