AEG FAVORIT 665 - Manual (Page 20)

Notes on installation
Water supply
Important note:
On appliances with a safety valve at the
water tap, the extension can also be made
with a permanently installed copper pipeline
(8—10 mm dia.).
Minimum water pressure:
around 1 bar (1 atm overpressure, 1 kp/cm^,
10 N/cm*). If your water pressure is under
1 bar, please ask our service centre for
advice.
Maximum allowable water pressure:
around 10 bar. For water pressure over 10 bar,
a pressure reducing valve (obtainable from
your dealer) must be fitted upstream.
Water drainage
The drain hose Is fastened at the back
of the machine by a plastic tape.
Remove the piastic tape and piace the drain
hose in the plinth recess (see Fig. 3/b).
The hose connection (19 mm dja.) supplied
with the dishwasher wili fit all commonly
available makes of sink trap. Secure
the hose with the supplied hose clip.
If you suspended the drain hose on a free­
standing appliance in a sink, you should then
use the supplied attachable bend
(see illustration opposite).
If you draw a string through the hole
(see arrow), you can also mount the bend on
a wall and thus prevent it from slipping off
(e.g. if the^ink edges are too wide).
20