AEG FAVORIT 665 - Manual (Page 16)

Cleaning the strainers
Coarse filter
Fig. 15
Remove the coarse strainer and clean it
under running water with a brush.
If food residues have become stuck,
take out the insert (Fig. 16) and remove
the food residues.
Then replace the insert firmly in the coarse
strainer and place it in the fine strainer.
Fine filter
Fig. 17
If necessary, also clean the fine strainer
and microfilter.
Twist it to the left and clean the upper
and lower sides.
Unscrew it anticlockwise and clean the top
and the underside of the strainer.
Then replace it so that the outside edge
rests correctly on the floor of the
machine (i.e. forms a tight fit). Then screw
on tight in a clockwise direction.
Never carry out a washing programme
without a strainer.
Care instructions
Never clean the screens and controls of your
appliance with commercially available
furniture cleaners and aggressive detergents.
If cleaning is necessary, use only lukewarm
water.
If you think your dishwasher is not working properly
Before calling our service centre, please check whether you can rectify the fault yourself
by following the instructions given below.
What should I check if....?
... the program will not start?
• Are the fuses in order?
• Have you closed the door properly?
... no water flows in?
• Have you turned on the water tap?
• Check the water supply hose
(it must not be kinked).
... the programme switch stops at the start
of cleaning (symbol inr ) or rinsing with
rinse aid (symbol )?
• Have you fully opened the water tap
(see page 13)?
• Check the strainer at the screwed
connection of the supply hose
(please clean if dirty).
• Is a minimum water pressure of around
1 bar available (see page 20)?
the crockery is not clean?
Did you select the correct programme?
Remember to use a programme suitable
for the nature and degree of soiling
of your crockery.
Did you arrange the crockery in
accordance with the instructions given
in this manual? The sprayed water must
have access to all surfaces, both internal
and external. The baskets must not be
overfilled!
Have the spray arms been obstructed by
a piece of crockery or cutlery?
Please tpake sure that, for better drainage
of residual water at the programme end,
the upper spray arm obliquely tilts when
it comes to rest. When operational,
it automatically runs in the horizontal
position.
16