Audiovox Prestige PR-140 - Manual (Page 10)

BASIC OPERATION
Turning the Unit On/Off
Press @ for about one second to turn on the unit. All the
indicators and digit display will light momentarily, and
a tone will be heard. The indicator |T] will stay while the
unit is turned on. Press @ again for about one second to
turn off the unit.
• Antenna Position
Your portable cellular telephone is equipped with a dual
position antenna system.
This dual position antenna has been especially designed
to allow your phone to receive calls while the antenna is
down. However, for optimum performance and signal
strength or while operating in poor signal areas, it is
recommended that the antenna be fully extended.
Note: The antenna can be used in its fully extended or
fully retracted position only.
• Receiving Signal Strei^h Indicator ( T a l l l )
The number of shaded blocks indicates the Signal
Strength in your area. Four blocks show the maximum
level. The display will vary as you move with the unit.
If the signal is not strong enough to place a call, the
INO SVCl indicator will appear on the readout.
• Battery Level Indicator
You can always monitor the current battery voltage level
with the constant battery level indicator. The number of
blocks indicates the battery conditions as follows:
В а ■ ■ ■
в
■ ■
_
в а ■
_ _
в а _ _ _
-;в ■ ■ ii
Full charge
Normal phone call
Short phone call
Recharge battery
(Flashing is discharged)
To Store a Number in Memory
1. Press then enter the phone number.
2. Press (0), (^, then enter the memory address
(01 through 30).
Example: Press (©, key (£) then (§), the
displayed number will be stored into memory
address 15.
To Recall a Number from Memory
Press , then enter the memory address (01 through
30).
Example: Press @ (© , key (£) then , the number
stored in memory address 15 will be dis­
played on the readout.
To Review the Prefix
(Number longer than 8 digits)
After pressing @), (£), hold down the second digit of the
memory address.
Display Own Telephone Number
You can see your system ID number anc^our own phone
number on the readout. Press ®, кет (©. Your system
ID will be displayed while the key (© is held down.
Repertory Memory Scroll
This feature is useful in finding a certain phone number
by scrolling the repertory memory from one of the desig­
nated starting addresses.
1. Press (£), key [x] then (J).
H is the digit to assign the starting address as
follows.
X Starting address
0 01
1 11
2 21
2. Press (£) or (£) .
(£) : Scroll upward (with roll back to 01)
: Scroll downward (with roll up to 30)
Memory address and the last 5 digits of the stored
number will be displayed on the readout as follows.
Example: r^OT 1 3l'-i 1^1
Address No. Tel. No.
Note: In this scroll feature, any vacant memory
address(es) will be skipped.
17 18