Audiovox DST 961 - Manual (Page 11)

DIALING FROM MEMORY
* —Press TALK to get dial tone.
* Press MEM.
* Enter a 2 digit location number (00..20)
* The number stored in that location will
be automatically dialed.
MEMORY (SPEED) DIALING
CHANGING STORED NUMBERS
To change or replace a stored number,
simply store a new number in the desired
memory location following the instructions
listed in STORING MEMORY DIAL
NUMBERS.
DELETING STORED NUMBERS
To delete a stored number from memory
do the following:
* Press PROG to enter program mode.
* Enter the memory location (00..20).
* Press MEM to exit program mode.
NOTE;Stored numbers are retained in
memory even if the base loses its power or
the handset battery is removed.
STORING SPECIAL CODES
To Insert a pause In a phone number,
press HOLD at the appropriate point when
entering ttie number.This inserts a 2 second
pause. For longer pauses, press HOLD two
or more times. Each press makes the
pause 2 seconds longer, and is treated as a
stored digit.
If your phone is connected to a PBX you
can store the PBX access number and a
pause before the phone number. For
example, to store 9-PAUSE-555-1234 in
memory location 08, do the follownng;
* Press PROG
* Press 08 (memory location)
* Press 9
* Press HOLD (pause)
* Dial 5551234
• Press MEM ^
ADDITIONAL OPERATING TIPS
If the handset is moved to a point where
the base unit and handset can no longer
communicate, the handset will make a quick
series of beeps to signal Out of Range.
OUT OF RANGE WHEN PHONE IS ON
If you are presently engaged in a phone
conversation move closer to the base. If the
base unit does not communicate with the
handset within 25 seconds of losing contact,
it will automatically hang up.
OUT OF RANGE WHEN PHONE IS OFF
If the phone is OFF, the handset and base
still monitor each other to make sure that they
can communicate. If the hsmdset is moved
out of range, the handset will make a series
of beeps, and then the PHONE and MUTE/
LOW ВАТТ LEDS will flash continually. The
handset will re-link with the base
automatically once it is brought back within
range. The unit will then be able to receive
and place calls.
When the base unit is unplugged from the
power supply, the handset will give the Out
of Range warning beep. Plug the base In
again and this will stop.
NOISE OR INTERFERENCE
Your Audlovox DST961 cordless
telephone has auto-channel scan circuitry,
which will detect excess noise and change
the channel of the phone to reduce it. This
is done automatically.
Since the Audiovox DST961 is a fully
digital phone, it does not suffer from noise
associated with regular cordless phones.
At times you may experience occasional
rop outs especially at the extreme edges
of the phone range. Simply move closer
to the base unit and this will disappear.
AUTOMATIC SECURITY CODING
Your Audlovox DST961 phone is
-3D-