Avanti WC400YGB - Manual (Page 9)

Remove the light bulb cover by puling the bottom end of the light
bulb cover gently.
Unscrew the bulb (D
Replace with a 10 watt-refrigerator bulb that is the same shape and
size.
Replace the light bulb cover j and tighten screw .
zCZv^
V
'S' Bulb Holder
S- Bulb Holder Case
X- Bulb Cover
0 Switch
Screw
Cleaning Your Wine Cooler
• Turn the temperature control to "OFF",unplug the wine cooler, and remove
the bottles.
• Wash the inside with a warm water and baking soda solution. The solution
should be about 2 tablespoons of baking soda to a quart of water.
• Wash the shelves and trays with a mild detergent solution.
• The outside of the wine cooler should be cleaned with mild detergent and
warm water.
• It may also be necessary to periodically wipe the bottom part of the storage
area, as the wine cooler is designed to retain humidity ,and condensation
may collect there.
Maintenance of Your Wine cooler
• Power Failure
Most power failures are corrected within a few hours and should not affect
the temperature of your wine cooler if you minimize the number of times
the door is opened. If the power is going to be off for a longer period of
time, you need to take the proper steps to protect your contents.
Vacation Time
During long absences, remove all the bottles; unplug your wine cooler, clean
your wine cooler, and leave the door open slightly to avoid possible formation
of condensation, mold, or odors.
Moving Your Wine Cooler
• Remove all the bottles.
• Securely tape down all loose items inside your wine cooler.
• Turn the leveling screws up to the base to avoid damage.
• Tape the doors shut.
• Be sure the wine cooler stays in the upright position during transportation.
Water Collection Tray
• When the compressor is not operating, water drops collect and drain
through the outlet in the inner back wall into the drain pan located above
the compressor.
• To clean tray if necessary, remove 2 screws holding it against the back
wail.
• Pull the tray forward and replace it once cleaned.
-8