Avanti WC400YGB - Manual (Page 8)

©-Lower Door Hinge
® -Front Leveling Legs
©-Left Front Leg
©-Door Frame Pin
® -Hinge Plug(Door Frame)Left Side
©-Door Hinge Bolt
OPERATING YOUR WINE COOLER
^ Temperature Control
• The first time you turn the unit on, set the temperature control to
"MAX" position.
• The settings of the temperature control are "OFF", "MIN", "NORMAL
" and "MAX". After 20 minutes, adjust the temperature control setting
to "NORMAL". The setting of "NORMAL" should be correct for home
or office wine cooler use.
• To turn the wine cooler off, turn the temperature control to "OFF".
NOTE:
■ Turning the temperature control to "OFF" position stops the cooling
cycle, but does not shut off the power to the wine cooler.
■ if the unit is unplugged, power lost, or turned off, you must wait 3 to
5 minutes before restarting the unit. If you attempt to restart before
this time delay, the wine cooler will not start.
■ The range between "MIN" and "MAX" is from 48°F to 61 °F, which
is ideal for the storage of wines.
CARE AND MAINTENANCE
> CHANGING THE LIGHT BULB
NOTE:
All parts removed must be saved to do the replacement of the light
bulb.
Before removing the light bulb, either unplug the refrigerator or
disconnect the electricity leading into the refrigerator at the main
power supply. Failure to do so could result in electrical shock or
personal injury.
“ Move the light switch B to the "OFF" position.
- Remove the screwCö:
- 7 ~