beautypg.com

Avanti WC400YGB User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

H

Warning

H

Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord Is damaged, have it replaced by an
authorized Avanti Products service center.

> Reversing the Door Swing of Your Wine Cooler

This wine cooler has the capability of either opening the door from the left or

right side. The unit is delivered to you with the door opening from the left
side. Should you desire to reverse the opening direction, please follow these
instructions.

NOTE;

All parts removed must be saved to do the reinstallation of the door.

Reversing of the Wine Cooler Door

Remove the two screws(1)that hold the lower hinge(2)(right side)to the

frame. Also, remove the screw-type leveling front leg(3).

Remove the left front leg(4) and transfer it to the right side.
Lift the door and place it on a padded surface to prevent scratching it.

Make sure to remove the spring(5) located inside the upper right hole
of the door and the upper right side pin(6).
Remove the plug button(7)from the upper left hole of the door and

transfer it to the uncovered hole at the right side. Be sure to press the

button firmly into the hole.
Insert the upper pin(6) previously removed from the right side (step 3)

and transfer it to the other hole at the left side of the top frame.

Insert the spring(5)previously removed(step 3)inside the upper left side

hole of the door.

Set the door in its place making sure the pin(6)enters the bushing at

the lower upper frame section(hole).
While holding the door in the closed position, secure the lower left

hinge(2)previously removed(step 1 ¡.Before placing this lower hinge,

remove the upper bolt-pin(8) and reverse the direction of the hinge.

Insert the bolt-pin(8)and do not tighten until the top of the door is

leveled with the counter top.

Insert the two screws(1 ¡previously removed(step 1¡and tighten them.

6

-