Audiovox DT921C - Manual (Page 14)

USING THE WALL MOUNT
ADAPTOR ■
1. Position the wall mount braclcet
on the base.
Une up Uia tabs on the wall mount
adaptor with the holes on the
bottom ot Iha base (Figure 1).
Snap the wall mount bracket firmly
fn piece. V
2. Mount the base on the wall
Position the base so the mounting
studs win fit into the holes on the
bottom of the base. Position the
power oord to extend down the wall
the phone is to be mounted on.
Slide the báse down on the
mounting studs until it looks into
place.
3. Connect the telephone line cord.
The telephone fine cord has a
snap-in plug at each end. insert
one ot the plugs into the jack on the
bottom of the base. Insert the other
end of the plug into the wai! jack.
4. Plug the AC adaptor Into an
etectn’cal outiet and the DC
connector into the power jack
faceted on the back of the Base
Unit.
11
“(g)-
Snifll. 11^11 AM