Bogen DMP-06 - Manual (Page 3)

A
• • •
MASTER BASS TREBL6
B
• • •
• • • • • • •
CHANNEL1 CHANNELS CHANNEL3 CHANNEL 4 CHANNELS CHANNELSPROGRAM
• • • • • • •
DMP06
FRONT PANEL CONTROLS AND INDICATORS
POWER Rocker-type switch illuminates when power has been applied.
LEVEL Bar-type LED meters provide a graphic display of the output levels.
A&B Continuous red illumination indicates possible signal clipping.
A&B CHANNELS 1-6 Individual level controls for module inputs 1 through 6.
A&B PROGRAM Level controls for the fixed program input.
A&B MASTER Master output level controls.
A&B BASS Provides ±10dB attenuation at 100Hz (with tone control switch IN).
A&BTREBLE Provides ±10dB attenuation at 10kHz (with tone control switch IN).
REAR PANEL CONTROLS AND CONNECTORS
LINE CORD Three-wire line cord supplies power to the amplifier.
AC BREAKER Press-to-reset AC circuit breaker protects against excessive current flow.
INPUT PORTS Card edge connectors accept plug-in modules.
PGM IN Fixed program input for high level source (e g., tape player or phono).
MUTE Terminals provided to activate mute bus. Requires a customer-supplied contact
closure. The PGM IN input and any module set for priority level 1 or 2 will be muted
by contact closure.
MUTE LEVEL Screwdiivei-adjustable mute level control for PGM IN input. 60dB range.
BRDG IN/OUT Allows strapping of mixing busses from another DMA amplifier. Output level is
independent of MASTER control; may be used as an output for tape recorder.
A&B OUTPUTS Screw-terminal strips for connection to direct and transformer-coupled outputs.
A&B TONE CONTROLS IN: Enables front panel bass and treble controls.
OUT: Bypasses tone controls for flat response.