Autostart AS-1795 - Manual (Page 6)

Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the Valet button as above.
Getting into Vaiet Mode
• Hold the UNLOCK and start buttons simultaneously for 3 second.
• The Parking Lights will flash 3 times.
The LED on the antenna will remain on solid.
Getting out of Vaiet Mode
• Hold the UNLOCK and start buttons simultaneously for 3 second.
• The Parking Lights will flash 2 times.
The LED on the antenna will turn off.
Panic Mode
Note: Panic Mode can only be activated if the horn has been adequately configured by your
installer.
Press and hold the stop button for more than 3 seconds until the sound signal starts and the
parking lights flash.
Panic Mode will automatically shut down after 30 sec.
Note : To stop Panic Mode before the end of its delay, press the lock or unlock button until
the sound signal stops.
Quick Lockout^ M
(Also called Secure Panic.) For fast protection in emergency situations, the system will lock all
doors when you press the brake pedai whiie you hear the sound signai. (Quick Lockout is
only available when Panic Mode has been set off.)
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3 minutes (or for
8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends after 24 hours.
To enter Coid Weather Mode:
Press and hold the start button for 3 seconds until the parking lights flash three times.
To exit Coid Weather Mode, do any one of the foiiowing actions:
Open the hood.
Start the engine by remote.
Turn the ignition key to the ignition on ( run ) position.
Press and hold the start button for 3 sec. (the parking iights wiii fiash once).
If Safe Start is enabied, you can activate Coid Weather Mode by
Pressing and releasing the start button, then
Pressing and holding the start button until the Parking Lights flash 3 times
Extended Run Time
With the vehicle running under a remote start, pressing and holdinfl the start button for more tha^
|1 second will reset the run time counter to zero and restart the run time cycle from the beginning.
To stop the vehicle, at any moment, simply press the stop button. This procedure can only be
carried out once per remote start.
Example: if your Module is programmed for a run time of 3 minutes and your vehicle has been
running for 2 minutes already, pressing the start button will reset the counter to zero and the
Engine will run for another cycle (in this case, 3 minutes).
P. 6 User Guide
Advanced Features: Installation-programmable Options
The Remote Car Starter was designed with flexibility and OEM integration in mind. With its
programmable options, this unit can single-handedly control nearly any electrical system in your
vehicle.
Caution : The programming of your system should be left to a professional. Changing any
one of the settings may affect the operation of your Remote Car Starter.
Remote Door Locks
If your Remote Car Starter was installed with the Remote Door Locks option, you will have the
convenience of remote keyless entry. See section Arming the Starter Kiii, earlier in this Guide, for
further instructions on remote door locking and unlocking.
Priority Door Access
If the Remote Door Locks option is installed on your vehicle, this safety feature allows you to
unlock solely the driver's door with a single press of the unlock button on the transmitter; upon a
second press of the unlock button, all the other doors will unlock.
Ignition-controlled Door Locks
This is an added security feature. If your Remote Car Starter was installed with the Ignition-
Controlled Door Locks option, the doors will automatically be locked as soon as the ignition key is
turned to the ignition on ( run ) position while the brakes are pressed. When the key is turned to the
off position, the doors will automatically be unlocked.
Ignition Re-lock
On Remote Car Starters of this series, when Ignition-controlled Door Locks are enabled and the
ignition key is in the ignition on ( run ) position, should any door be unlocked and opened, all doors
will be relocked next time the brake pedal is pressed.
Secure Lock
Before it can remote-start your vehicle, the Remote Car Starter must first disarm the factory
security system. The Secure Lock feature may be required on certain vehicle models with factory
security systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, Secure Lock will rearm your factory security system.
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the trunk button for 3 seconds on the remote transmitter.
The Starter Kill and the Anti-grind Feature
With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the Starter Kill is armed. If your Remote Car Starter was installed with the Starter Kill
option, one will not be able to start your vehicle with the key unless the system has been unlocked
and disarmed first, or put into Valet Mode.
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the crank position.
Safe Start
If this feature is enabled, the user must press the start button 2 times within 3 seconds to remote­
start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing with the
transmitter.
User guide P. 7